Directions of Use

iPlex repair treatment is a convenient and effective way to improve the health of your hair. It can be done together with bleaching, perming and hair rebonding services. For severely damaged hair, you can apply the stand-alone treatment. While the treatment takes a little  longer, it will significantly improve the health of your hair.

 

Refer to the information below to learn more about how the iPlex repair treatment works.

  •  

     

     

     

     

     

     

     

     

     

    1. Bleaching

    1. Mix an equal amount of bleaching powder and developer together.
    2. Add iPlex No. 1 Bond Creator equal to ¼ of bleaching powder used, and mix into the solution.
    3. Carry out the bleaching procedure as usual.

     

  •  

     

     

     

     

     

     

     

     

     

    3. Hair Rebonding

    1. Apply the rebonding lotion no. 1 onto the hair, and leave to absorb for 15-30 minutes.
    2. Rinse and towel-dry the hair (no shampoo needed).
    3. Mix 20ml iPlex No. 1 Bond Creator with 60ml of water (1:3 ratio dilution) and apply on the client’s hair thoroughly.
    4. Towel-dry and briefly blow-dry the hair until it is damp, then iron the hair as per usual.
    5. Complete the remainder of the hair rebonding procedure as per usual.

     

  •  

     

     

     

     

     

     

     

     

     

    4. Stand-alone Treatment

    1. After shampoo, towel dry the client's hair.
    2. Mix 20ml iPlex No. 1 Bond Creator with 60ml of water. (1:3 ratio dilution) and apply on the client’s hair thoroughly.
    3. Without waiting or rinsing, use a hair straightening iron (120°C, lowest setting) to iron the client's hair (3-5 strokes, about 15 minutes). There is no need to dry the client's hair completely. The main purpose is to allow the iPlex active ingredients to work on the client's hair under the effect of direct heat.
    4. Apply iPlex No. 2 Bond Booster from roots to end and work evenly through the hair.
    5. Again, use a hair straightening iron (120°C, lowest setting) to iron the client’s hair (3-5 strokes, about 15 minutes).
    6. Rinse off well and blow dry. No shampoo needed.

     

Copyright © 2016 Infinite Beauty Intl. All rights reserved.